Cross-platform Bluetooth API for Go and TinyGo. Supports Linux, macOS, Windows, and bare metal using Nordic SoftDevice or HCI
22553053ff
Only scanning has been implemented so far. The most work was really just understanding WinRT well enough to get to this point. |
||
|---|---|---|
| .circleci | ||
| examples | ||
| s132_nrf52_6.1.1 | ||
| s140_nrf52_7.0.1 | ||
| winbt | ||
| .gitattributes | ||
| .gitignore | ||
| adapter.go | ||
| adapter_linux.go | ||
| adapter_s132.c | ||
| adapter_s132.go | ||
| adapter_s140.c | ||
| adapter_s140.go | ||
| adapter_sd.go | ||
| adapter_windows.go | ||
| error_sd.go | ||
| gap.go | ||
| gap_linux.go | ||
| gap_sd.go | ||
| gap_windows.go | ||
| gatts.go | ||
| gatts_linux.go | ||
| gatts_sd.go | ||
| go.mod | ||
| go.sum | ||
| LICENSE | ||
| mac.go | ||
| Makefile | ||
| README.md | ||
| uuid.go | ||
| uuid_sd.go | ||
| uuid_test.go | ||
Go Bluetooth
Bluetooth API for embedded devices.
This package attempts to build a cross-system Bluetooth API written in Go. It specifically targets embedded devices that are supported by TinyGo.
At the moment, there is only support for the S132 SoftDevice (binary driver) on Nordic Semiconductors devices.
Flashing the SoftDevice
Flashing the SoftDevice can be tricky. If you have nrfjprog installed, you can erase the flash and flash the new BLE firmware using the following commands.
nrfjprog -f nrf52 --eraseall
nrfjprog -f nrf52 --program s132_nrf52_6.1.1/s132_nrf52_6.1.1_softdevice.hex
After that, don't reset the board but instead flash a new program to it. For
example, you can flash the Heart Rate Sensor example using tinygo:
tinygo flash -target=pca10040-s132v6 ./examples/heartrate